There should be no gap between the base of the wall plate and the end of the rod.
Double shower curtain rod installation instructions.
Install the first bracket by screwing it into place.
Then move on to the next hole repeating the same process.
The method may vary by manufacturer.
How to install spring loaded shower curtain rods.
Before installing installation curved double shower curtain rod pencil level tape measure screwdriver drill hammer hacksaw drill bit 1.
Place the wall brackets onto the ends of the shower rod and tighten the set screws secure.
Using the hardware that is incl.
If there is a stud in your mounting location use wood screws to attach the wall brackets.
Hold it while you level the rod.
Drill pilot holes for the wall anchors.
Lay the rod sections on the floor.
Starting from the left side thread one ring through the holes of both the curtain and the liner.
For rods 84 and longer assemble with the connector piece.
If not trim with a hacksaw.
In this video we walk you through the steps in which you need to take to install your kenney double curtain rod in your home.
It may use spring loaded clips that fit into holes in the bracket or screws that secure the rod to the bracket.
Rotate the wall plate until it fits flush with the end of the rod.
Once level have an assistant mark where the rod intersects the other wall.
7 slide the 2nd wall plate into the rod as shown below see figure d.
Continue threading until all 12 rings have been threaded through all 12 holes.
Attach the rod and brackets to the wall with the mounting hardware provided.
Then install the rod and place a level across the length of the rod.
Extend the adjustable curved shower rod as needed until it is the correct length then install the other end of the rod into the bracket on the opposite wall.
Straight double shower curtain rod installation 5.
6 with the fronts of the 2 covers facing together slide the covers onto the rod see figure c.
Verify that the rod sections are the proper length for your installation.
Thread the shower curtain hooks rings through the curtain and liner.
Once you find the proper height level the shower rod.
Install your brackets using these marks for a level rod.